Checkmates Link :

https://community.checkpoint.com/t5/Enterprise-Appliances-and-Gaia/quot-fw-ctl-get-int-fwha-perform-chain-forward-quot-command/m-p/102110

Hi Team,

When I run the below command showing “Get Operation Failed”.

“fw ctl get int fwha_perform_chain_forward”

Security Gateway OS : R80.30 (Take_196 JHF)

What is the use of this command ?

is this command not relevant in R80.30 ?

Answer by Guy_Elyashiv (Employee, Check Point Software Tech)

This command was used to enable or disable the “forwarding mechanism”, this mechanism was deprecated in R80.20 and was replaced by a new mechanism called “correction layer” which is always enabled, therefore the commands mentioned are no longer available.