Checkmates Link :
https://community.checkpoint.com/t5/Enterprise-Appliances-and-Gaia/quot-fw-ctl-get-int-fwha-perform-chain-forward-quot-command/m-p/102110
Hi Team,
When I run the below command showing “Get Operation Failed”.
“fw ctl get int fwha_perform_chain_forward”
Security Gateway OS : R80.30 (Take_196 JHF)
What is the use of this command ?
is this command not relevant in R80.30 ?
Answer by Guy_Elyashiv (Employee, Check Point Software Tech)
This command was used to enable or disable the “forwarding mechanism”, this mechanism was deprecated in R80.20 and was replaced by a new mechanism called “correction layer” which is always enabled, therefore the commands mentioned are no longer available.
